LUPINE FRIENDLY tags. I've spoken with my representative at Lupine and this will not in any way void your warranty with Lupine by adding these to your Lupine collars. The only thing is if you send it in on the collar as a trade in to be replaced, they will not you send the tag back. See below for installation instructions.
These tags come with rivets that owners use to attach the tag to the pets' collar with. According to the manufacturer they are easy to attach.
Large tags 6 lines of text per side, 22 characters including spaces per line. Small tags 4 lines of text per side, 18 characters including spaces per line.
INSTALLATION INSTRUCTIONS: I used common household tools found around most homes, a large nail, a piece of wood and a hammer. I layed the rivet tag over the back of the collar where I would want it to lay. Use either a pencil or a pen to mark the holes where you'll want to punch openings through the material of the collar for the rivets. With the collar laying on a thick piece of shop wood, hammer the nail through the marked areas of the collar making sure it pushes through each side of the collar easily. You may want to rotate the nail around to stretch the opening as much as possible. Put the longer thinner pole of the rivet through the tag then through the front of the collar on each side. The smaller snap like portion goes over the post from the back of the collar. Use the hammer to set the snap tight against the tag. It should seat tightly.
